Toyota MR2 211 — CYLINDER BLOCK

Parts diagram

11401BLOCK SUB-ASSY, CYLINDER

11415COCK SUB-ASSY, WATER DRAIN(FOR CYLINDER BLOCK)

11415APLUG, WATER DRAIN COCK(FOR CYLINDER BLOCK)

11416BOLT(FOR CRANKSHAFT BEARING CAP SET)

11425BOLT, STUD(FOR OIL FILTER)

11431APLUG, TIGHT, NO.1(FOR CYLINDER BLOCK)

11431BPLUG, TIGHT, NO.2(FOR CYLINDER BLOCK)

11431CPLUG, TIGHT, NO.3(FOR CYLINDER BLOCK)

11432APLUG, W/HEAD TAPER SCREW, NO.1

11432BPLUG, W/HEAD TAPER SCREW, NO.2

11434APIN, STRAIGHT(FOR TIMING GEAR COVER SET)

11434CPIN, STRAIGHT (FOR CYLINDER HEAD SET)

11434DPIN, STRAIGHT(FOR ENGINE REAR OIL SEAL)

11434GPIN, STRAIGHT(FOR END PLATE)

11448ORIFICE, CYLINDER BLOCK OIL

11452GUIDE, OIL LEVEL GAGE

11459SUPPORT, OIL LEVEL GAGE GUIDE

11462LINER, CYLINDER

11475SHIM, CYLINDER LINER

12101PAN SUB-ASSY, OIL

12101APLUG(FOR OIL PAN DRAIN)

12101BGASKET(FOR OIL PAN DRAIN PLUG)

12151GASKET, OIL PAN

1301CRANKSHAFT & PISTON

→ Go to FIG 13-01

15301GAGE SUB-ASSY, OIL LEVEL

15605VALVE SUB-ASSY, OIL CHECK

15708NOZZLE SUB-ASSY, OIL, NO.1

9011608071

9011908156

9017908040

9338118016

31 parts on this diagram · 6 diagrams in section

CYLINDER BLOCK for Toyota MR2 211

This section contains 53 genuine Toyota parts for the CYLINDER BLOCK system of the Toyota MR2 211. Key components include: BEARING SET, PUMP DRIVE SHAFT, COVER, VALVE PUSH ROD, GASKET(FOR VALVE PUSH ROD COVER BOLT), WASHER, SEAL(FOR VALVE PUSH ROD COVER BOLT), GASKET, VALVE PUSH ROD COVER.

Toyota MR2 211 CYLINDER BLOCK — Parts Diagram | ToyotaEPC